Stops

Inside stop (AI)

The inside stop is mounted to the inside of the belt profile at the end of the belt in corner situations. The workpiece carrier travels into the stop (up to the limit), which brings it into position before it is transported to a transverse section or a parallel main belt by a 90° or 180° transfer unit. The position of the workpiece carrier is not queried. For this to happen, a separate sensor is required.

Included:

• 2 plastic stops with mounting screws and slotted nuts

Outside stop (AA)

The outside stop is also mounted at the end of the belt in corner situations, but to the outside of the belt profile. The workpiece carrier travels into the stop (up to the limit), which brings it into position before a 90° transfer unit transports it from a transverse section back to a main belt moving in a perpendicular direction. The position of the workpiece carrier is not queried. For this to happen, a separate sensor is required.

Included:

• 1 plastic stop with aluminium holder, mounting screws and slotted nuts